Exerpeutic Treadmill with Pulse Owner's Manual Page 27

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 26
Belt Adjustment:
Aw the belt is adjusted at the factory; it may come loose during transportation
and/or from use. After prolong use of the treadmill, the belt will stretch out.
If the belt begins shifting to the left, turn on the main power switch of treadmill
and let the belt run at a speed of 1-1.5 MPH. Using the Allen wrench
provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise
direction. You should see the belt start to correct its position by moving back
toward the center. Repeat the above procedure until the belt is properly
centered. If the belt begins shifting to the right, repeat the above procedure
but turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction
instead of the left. You should see the belt start to correct itself by moving
back toward the center. Repeat the above procedure until the belt is properly
centered. If the belt is slipping during use, turn off and unplug the treadmill.
Using the Allen wrench provided, turn both left and right rear roller adjustment
bolts 1/4 turn in the clockwise direction, then turn on the main power switch of
treadmill and let the belt run at the speed of 1-1.5 MPH. You should now walk
on to the belt to determine if the belt is still slipping. Repeat the above
procedure until the belt no longer slips.
Lubrication:
The treadmill has already been coated with a "Silicone Oil". Silicone oil is a
non-volatile oil and by the time you receive should have permeated through
the belt. There will be no need to re-apply the oil under normal
circumstances. To maintain the belt, the "Silicone Oil" may be re-applied
once the resistance has been increased and the belt starts rubbing against the
running deck. To re-apply “Silicone Oil” to the treadmill, lift up the belt, one
side at a time, and apply the oil directly to the center of the running deck.
Allow the silicone oil to 'set' for one minute before using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition,
do not use any other type of oil; otherwise the treadmill will be damaged.
Do not over-lubricate the walking board. Excess lubricant should be
wiped off with a clean towel.
BELT ADJUSTMENT & LUBRICATION
26
Page view 26
1 2 ... 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments