Exerpeutic 1111 Owner's Manual download pdf (Page 14)

4. Seat Sliding Tube, Back/Seat Support Bracket, and Handlebar Installation

Remove eight M8x15 Bolts (23) and eight Ø8 Washers (24) from the Back/Seat Support

Bracket (1) and Seat Sliding Tube (15). Remove bolts with the Allen Wrench provided.

Insert the Seat Sliding Tube (15) into the Bushings (54) of the Rear Main Frame (3).

Attach the Seat Sliding Tube (15) to the Back and Seat Support Bracket (1) with eight

M8x15 Bolts (23) and eight Ø8 Washers (24) that were removed. Tighten bolts with the

Allen Wrench provided.

Adjust the seat position and insert the Round Knob (17), M12x33 Triangle Knob (77), and

M12x27 Triangle Knob (66). Turn the Round Knob (17), M12x33 Triangle Knob (77), and

M12x27 Triangle Knob (66) in the clockwise direction to tighten.

Attach the Handlebar (13) onto the Back and Seat Support Bracket (1) with two M8x45 Bolts

(70), two Ø8 Curve Washers (25), two Ø8 Washers (24), and two M8 Cap Nuts (32).

Tighten bolts with the Multi Hex Tool with Phillips Screwdriver provided.

Connect the Middle Section Hand Pulse Sensor Wires (55) from the Rear Main Frame (3) to

the Hand Pulse Sensor Wire (68) from the Handlebar (13).

Hardware:

Allen Wrench S6

Tool:

Multi Hex Tool with

Phillips Screwdriver

2 Bolts (M8x45)

2 Curve Washers (Ø8)

2 Washers (Ø8)

2 Cap Nuts (M8)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Exerpeutic 1111 Owner's Manual Page 14